Page 1 of 1

front plate holder for small custom plate

Posted: Sat, 10 Jan 2015, 22:24
by rkeech
hi,

I want some advice in mounting a small custom front plate on a Volt.

The front plate holder is 350mm x 110mm. My plate is 250mm x 100mm.
A full-size plate is 370mm x 130mm.

When my plate is mounted there is a lot of the grey plastic holder showing which is unsightly.

Does anyone know how the front plate holder is fixed to the bumper? There are no screws.

I figure my options are either:

a. modify the existing plate holder; or

b. make a custom plate holder; or

c. put a small crease in the plate and fit conformal to the bumper.


Any thoughts?